Resetting the ERM allows you to register the device with a new bike (either TPI or TBI with v2.0+ firmware)
The cost to reset your ERM is equivalent to the cost to reflash an individual ECU through one of our worldwide ECU reflash centres. Resetting allows you to leave your previous ECU with a TSP tuned map.
Please note: Once your ERM is paired to a new bike, you can no-longer use the ERM with the old bike. The ERM is designed to only pair with one bike at a time.
After your purchase has been completed, you will receive an email containing a registration file and the below instructions on how to reset your ERM. Please contact us if you do not receive this email within 2 hours of purchase.
Instructions after receiving device reset email:
- Download the attached registration file on to your computer
- Ensure your bike is running the tune that you want it to be left with, and disconnect the ERM from your bike.
- Connect the ERM to your computer using the supplied USB cable
- Load the attached registration file onto your ERM by connecting to it with ERM Manager, pressing the ‘Registration’ button on the left navigation pane, then pressing the ‘Upload Registration’ button and selecting the registration file downloaded in step 1.
- After this is complete, on the ERM go to the ‘Extras’ tab, then press the ‘Reset’ button on the ‘Activation’ page.
- Once the reset is complete, it is ready to be set up again in the ERM portal as a new device.
- If you have purchased Pro/Pro+ Mode, it will remain on the ERM it was purchased on.